Metal Tech 2003-09 GX470 Pegasus Rear Swing Out Bumper Stage 1

Metal-Tech 4x4 Lexus GX470 Pegasus Rear Swing Out Bumper Stage 1

Pegasus is a one piece no cut rear bumper with integrated 3/4" pull points and built in rear facing pockets for 20w flange mount LED backup lights. It uses MT4x4's custom machined 2000lbs Motion X Pivot System with two tapered radial bearings and grease seal that moves the one piece swing out arm with ease.

All Lexus GX470 rear swing out bumpers include a stainless steel 2000lbs rated locking latch bolted on with machined High-density polyethylene (HDPE) replaceable wear blocks for the beams contact points into the locking cradle. The swing out beam features an adjustable offset spare tire mount holding up to a 35" spare without blocking the tail lights,  a UHF/CB antenna mounting point, and a built in horizontal Hi-Lift Jack mount as standard.

The Pegasus is a rear bumper swing away tire carrier that uses an integrated 120lbs gas strut to assist in opening the swing out beam loaded with auto locking open and closed positions. As a result, the swing arm can be opened safely when the vehicle is off axis.

On the side of this Lexus GX470 rear swing out bumper we built in side steps pockets to provide quick access to your roof. Each step pocket features optional mounting points for marine 12v accessories ports and an LED step light that will illuminate the step pocket, both available as an optional accessory.

Optional Utility Rack and 2 Locking Fuel/Water Can Holders which are made of single weld, laser cut, 5052 aluminum to be strong and light weight are available.

We offer two optional bolt on receiver hitches or run w/out, (1) shown under frame mount full GVW towing capacity, (2) high tuck above the frame with light duty use like off road trailer etc. 

If your GX470 has a back up camera then you will need our optional Backup Camera Mount Relocation Kit to relocate the factory camera to the spare tire carrier. 

The Lexus GX470 rear swing out bumper is designed so all moving parts are fully serviceable, rebuildable, and replaceable, which ensures a long service life for the product. 

Features:

• Bumper shell
• Swing out arm w/ tire carrier and license plate mount
• Hi-Lift Jack mount
• Antenna mount
• Rear pockets for optional LED back up lights
• Side Step Pockets for optional power ports and LED step lights
• Stainless Steel latch with HDPE landing pads
• All mounting hardware

Optional Accessories:

• Metal-Tech Standard Receiver (SKU #MT-34217)
• Metal-Tech High Tuck Receiver (SKU #MT-34217H)
• Metal-Tech GX470 Backup Camera Mount Relocation Kit (SKU #MT-53210)
• Metal-Tech Pegasus Utility Rack (SKU #MT-GX470-3001)
• Metal-Tech Fuel Can Holder (SKU #MT-53109)
• Metal-Tech 3rd Fuel Can Holder Add On (SKU #MT-7501)
• OPOR Rear License Plate LED Lights (SKU #OPOR-LED-LP)
• OPOR 12v Dual Plugs for step pockets (SKU #OPOR-54213)
• OPOR LED Step Lights for step pockets (SKU #OPOR-54812)
• OPOR 20w LED flood light (SKU #OPOR-LED-DM03-12AM-F)

Estimated Install Time: 7 hours

Install Guide

Stage 1 Bumper Additional Vehicle Weight: 151lbs