Metal Tech 4x4 Lexus GX460 Lancer Swing Out Rear Bumper
The GX460 is a proven overland platform known around the world as a Land Cruiser Prado 150. We designed, engineered, and tested the Lancer rear bumper to give you added utility and protection needed while using serviceable and replaceable moving parts so the bumper keeps performing the life of the product.
The GX460 rear swing out bumper uses our custom machined 2000lb Motion X Pivot System with two tapered radial bearings and grease seal that move the swing out arm with ease, even when fully loaded with accessories. The swing out is assisted by an integrated 120lb gas strut, auto locking in the open and closed positions to make opening while the vehicle is off axis safe and easy.
The swing out beam features an adjustable and lockable offset spare tire mount holding up to a 35" spare without blocking the tail lights and a license plate mount. There is a built in horizontal Hi-Lift Jack mount located low on the swing arm beam and a UHF/CB antenna mounting point up high. The swing arm is secured in place with a stainless steel 2000lb rated locking latch resting on machined High-density polyethylene (HDPE) replaceable wear blocks for the swing arm contact points into the locking cradle preventing metal on metal wear and rattling on the trail, and a long service life.
We integrated 3/4" recovery points in line with the chassis for strong and reliable rigging in recovery situations. The bumper shell features rear facing cut outs for optional 20w flange mount LED backup lights helping illuminate the trail while reversing. There are two laser cut side step pockets on both sides of the bumper to make roof cargo access easier. The step pockets have cut outs for optional 12v marine grade power ports and LED step lights. We also designed this GX460 rear swing out bumper to work with the factory Lexus back up sensors for added convenience.
We offer two optional bolt on receiver hitches, (1) under frame mount full GVW towing capacity, (2) high tuck above the frame with light duty use like small off road trailer or bike carriers etc.
The Lancer Rear Bumper Stage 3 includes:
- Bumper shell
- Swing out arm w/ tire carrier and license plate mount
- Hi-Lift Jack mount
- Antenna mount
- Rear pockets for optional LED back up lights
- Side Step Pockets for optional power ports and LED step lights
- Stainless Steel latch with HDPE landing pads
- All mounting hardware
- 2 OPOR Flange Mount Reverse LED Lights
- Utility rack
- 2 Metal Tech Aluminum Locking Fuel Can Holders
- Metal-Tech Standard Receiver (SKU #MT-34217)
- Metal-Tech High Tuck Receiver (SKU #MT-34217H)
- Metal-Tech 3rd Fuel Can Holder Add On (SKU #MT-7501)
- OPOR Rear License Plate LED Lights (SKU #OPOR-LED-LP)
- OPOR 12v Dual Plugs for step pockets (SKU #OPOR-54213)
- OPOR LED Step Lights for step pockets (SKU #OPOR-54812)
Estimated Install Time: 7 hours
Stage 3 Bumper Additional Vehicle Weight: 203lbs